Engine cooling system device Cooling system: 1 - outlet hose of the radiator; 2 - radiator of the cooling system; 3 - steam outlet hose; 4 - electric fan; 5 - radiator inlet hose; 6 -...
Removing and checking the thermostat We replace the thermostat in case of violation of the thermal regime of the engine, when the engine either overheats or does not heat up enough. When checking...
Removing the expansion tank We remove the expansion tank for replacement if it is damaged. If there is coolant in the expansion tank, we pump it out with a rubber bulb with a hose. Using...
Removing the radiator fan We remove the fan to replace its electric motor or impeller, as well as when dismantling the radiator of the cooling system. Disconnect the wire terminal from...
Removing the radiator We remove the radiator to check it for leaks (if a leak is suspected) or replacement if damaged. You can remove the radiator as an assembly with the fan, or by...
Removing the coolant pump The pump is replaced as an assembly if there is noise from the bearing or if the pulley is hard to rotate with the drive belt removed, there is a large radial...
Removing the low fan speed resistor The resistor is removed for replacement. You can perform the operation in the engine compartment from above. For clarity, we show the actions from below the...