Vehicle fuel system Chevrolet Lacetti 1

Engine power supply system device
Elements of the engine power supply system: 1 - fuel filter; 2 - fuel tank; 3 — adsorber; 4 - ventilation tube; 5 - filling pipe; 6 — air supply pipe to the...

Removal and disassembling the fuel module
We carry out the work to replace the fuel level indicator sensor, the fuel reserve indicator lamp resistor or the fuel module assembly. We release the pressure...

Removal the fuel rail and injectors
We remove the fuel rail to check the operation of the injectors and to replace them, as well as when dismantling the intake manifold. We release the pressure...

Removal the air filter
We carry out the work to flush the internal cavity of the filter housing, replace it, and also to access the right side of the engine compartment. Using a...

Removal the throttle assembly
We remove the throttle assembly to replace its failed sealing ring, to replace the assembly itself if the idle speed controller or throttle position sensor...

Removal the intake manifold
We remove the intake manifold to replace the sealing rings at the connection between the manifold and the cylinder head, to replace the manifold itself, and...

Removal the filler pipe
We remove the filler pipe for replacement if it is damaged, as well as if the ventilation pipe is damaged. Opening the fuel filler cap.. …using an 8 mm socket,...

Removal the fuel tank
We remove the fuel tank for cleaning or replacement. We carry out the work when the tank is empty or when there is no more than 5 liters of fuel left in it. We...

Removal the fuel vapor recovery system canister
We remove the adsorber for inspection or replacement if the tightness of its housing is broken (can be determined by the presence of the smell of gasoline and...

Removal the purge valve of the adsorber
We are carrying out work to replace the valve. Disconnect the engine management system wiring harness connector from the valve connector. By pulling the rubber...

Replacing the throttle cable
Replacing the throttle cable when it sticks (difficult movement of the cable in the sheath), caused by the breakage of some of the wires and their fraying, as...

Removal the recirculation valve
We remove the exhaust gas recirculation valve to replace its gasket or the valve itself. We remove the engine cover. Having pressed the lock of the engine...

Removal the valve and vacuum reservoir of the variable intake tract system
We remove the valve and vacuum reservoir of the engine intake tract length change system for replacement if they fail. We remove the engine cover. By pressing...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: