Vehicle fuel system Chevrolet Cruze 1

Features of the design of the engine power supply system
The power supply system includes elements of the following systems: fuel supply system, including the fuel tank, fuel module, fuel filter and fuel pressure...

Checking the pressure in the fuel system
The main indicator for determining the serviceability of the engine fuel system is the fuel pressure in the fuel rail. If the fuel pressure is insufficient,...

Decreased pressure in the engine fuel system
Warning: The fuel in the fuel system is under high pressure, so do not loosen the fuel line connections while the engine is running or immediately after it has...

Checking the tightness of fuel lines
1. Inspect the connection of the pressure pipe to the fuel rail, the connection of the injectors to the fuel rail. 2. Inspect the connections of the fuel vapor...

Replacing the air filter element
According to the manufacturer's recommendation, the air filter element should be replaced after 4 years of operation or 60 thousand km of mileage (whichever...

Removal and installation the air filter housing
The air filter is removed to gain access to other components in the engine compartment and in case of damage. You will need: a flat-blade screwdriver, a 10 mm...

Removal, repair and installation of the fuel module
If the engine power drops, there is increased noise, or periodic whining sounds are heard when the fuel pump is running, then most likely the fuel pump has...

Replacing the fuel tank and its filler pipe
If a fuel leak is detected in the tank, it is recommended to replace the tank. If the fuel pump screen often becomes clogged, remove and flush the tank. To...

Removal and installation the fuel rail
The fuel rail is removed for replacement if damaged (breakage of fittings), to replace injectors or to gain access to other components. You will need: 10 and...

Removal, inspection and installation of injectors
Signs of faulty injectors: difficult engine starting; unstable engine operation; engine stalls at idle; increased crankshaft speed at idle; engine does not...

Removal and installation the throttle assembly
Signs of a throttle valve that does not close completely may include increased idle speed and fuel consumption, and if the valve does not open completely, the...

Removal and installation the accelerator pedal
The pedal is removed for replacement if it breaks, and also for replacing the return spring if it is damaged. You will need: a flat-blade screwdriver, pliers....

Checking and replacing the pneumatic chamber of the intake manifold flap drive
You will need: TORX T30 key, screwdriver, medical syringe. 1. Remove the vacuum supply hose from the solenoid valve fitting. 2. Put the hose on the syringe and...

Removal and installation the electromagnetic valve of the intake manifold flap drive
1. Disconnect the wire from the negative terminal of the battery. 2. After pressing the lock, disconnect the wiring harness connector from the electromagnetic...

Fuel vapor recovery system
The fuel vapor recovery system prevents fuel vapors from escaping from the fuel system into the atmosphere, which have an adverse effect on the environment....

Removal and installation the fuel vapor recovery system canister
The fuel vapor recovery system canister is removed for inspection or replacement if a persistent gasoline smell appears due to its leakage. In addition, a...

Removal, checking and installation the purge valve of the adsorber
1. Disconnect the wire from the negative terminal of the battery. 2. Disconnect the supply hose from the valve fitting. 3. Remove the valve from the holder. 4....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: