Vehicle fuel system Chevrolet Lanos 1

Engine power supply system device
Elements of the engine power supply system: 1 - air filter; 2 - corrugated air supply hose to the throttle assembly; 3 - fuel tank; 4 — adsorber; 5 - filling...

Removal and disassembling the fuel module
We carry out the work to replace the fuel level indicator sensor, the fuel reserve indicator lamp resistor or the fuel module assembly. We release the pressure...

Removal the fuel rail and injectors
We remove the fuel rail to check the operation of the injectors and replace them, as well as to remove the fuel pressure regulator and intake manifold. We...

Removal the fuel pressure regulator
We remove the fuel pressure regulator to replace the failed sealing ring or the regulator itself. Considering that the screws that secure the fuel pressure...

Removal the air filter
We carry out the work to flush the internal cavity of the filter housing, replace it, and also to access the right side of the engine compartment. Using a...

Removal the idle speed control valve
We remove the idle speed control valve for inspection and replacement. With the ignition off, press the lock.. …disconnect the engine management system wiring...

Removal the throttle assembly
We remove the throttle assembly to replace it, as well as to replace the failed sealing gasket of the assembly. Disconnect the engine management system wiring...

Removal the intake manifold
We remove the intake manifold to replace the sealing gasket at the connection between the manifold and the cylinder head, as well as when repairing the...

Removal the fuel vapor recovery system canister
We remove the fuel vapor recovery system adsorber for inspection or replacement if the adsorber housing is not sealed properly (can be determined by the...

Removal the purge solenoid valve of the adsorber
We carry out the work to replace the valve or when dismantling the intake manifold support bracket. Failure of the adsorber purge solenoid valve can cause...

Replacing the throttle cable
Replacing the throttle cable when it sticks (difficult movement of the cable in the sheath), caused by the breakage of some of the wires and their fraying, as...

Removal the exhaust gas recirculation valve
We remove the exhaust gas recirculation valve to replace its gasket or the valve itself. To do this… …we press the lock of the engine control system wiring...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: