Car engine repair Chevrolet Lanos 1

Engine structure
Power unit (front view from the direction of the vehicle): 1 - catalytic converter of exhaust gases; 2 - air conditioning compressor bracket; 3 - heat shield...
There is 1 comment

Replacing the cylinder head cover gasket
Squeezing the clamp of the crankcase ventilation hose with pliers.. ..remove the hose from the cylinder head cover pipe. Using a 10 mm socket head, unscrew the...

Checking the condition and replacing the timing belt
According to the maintenance schedule, the timing belt should be checked after 50,000 kilometers, and the belt should be replaced after 60,000 kilometers. The...

Replacing the camshaft seal
It is convenient to assess the condition of the camshaft oil seal and replace it if necessary during routine maintenance to check the condition of the timing...

Replacing the front crankshaft oil seal
We replace the front crankshaft oil seal when traces of oil appear on the surfaces of the oil pump housing and the engine oil pan under the auxiliary drive...

Replacing the rear crankshaft oil seal
We replace the rear crankshaft oil seal when traces of engine oil leakage appear.. … from the hole located at the bottom at the junction of the clutch housing...

Replacing the low oil pressure sensor
We remove the low oil pressure sensor to check and replace it, and also if an oil leak appears at the junction of the sensor and the oil pump housing. By...

Removal the powertrain supports
We remove the supports for replacement if the rubber is torn or peels off from the metal parts of the supports, which can cause knocking when starting the...

Removal and installation the engine
We perform the work when it is necessary to repair or replace the engine. We show the engine dismantling operations on a car with power steering and air...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: