Electrical equipment of the car engine Chevrolet Lanos 1

Electrical equipment of a car
Description of the design The on-board network is direct current, with a nominal voltage of 12 V. The electrical equipment is made using a single-wire circuit:...

Removal the battery
We remove the battery for replacement when it fails, as well as for charging it and when repairing the car. We also dismantle the battery when removing the...

Removal the generator
We remove the generator for repair or replacement if it fails. Disconnect the wire terminal from the negative terminal of the battery. Remove the generator...

Disassembly and assembly of the generator
We disassemble the generator to check and replace the voltage regulator, rectifier unit, rotor, stator and bearings. We mark the relative positions of the...

Removal the starter
We remove the starter for repair or replacement if it fails, as well as when dismantling the engine. Disconnect the wire terminal from the negative terminal of...

Disassembling the starter
We disassemble the starter for repair, replacement of the traction relay, brush holder with brushes and drive elements. Before disassembling, use a screwdriver...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: