We also dismantle the battery when removing the gearbox, when replacing the pressure and driven clutch discs, release bearing, removing the flywheel from the engine and replacing the rear crankshaft oil seal.
Remove the protective cap from the wire terminal on the negative terminal of the battery.
Using a 10 mm wrench, loosen the clamp on the negative terminal of the battery and remove the clamp.
Remove the protective cap from the positive terminal of the battery.
After loosening the wire terminal with a 10 mm wrench, remove the terminal from the positive terminal of the battery.
Using a 10 mm socket head, unscrew the two nuts securing the pressure bar.
We remove the pressure plate with the racks.
We remove the battery from the engine compartment.
Before installing the battery, clean its terminals with a metal brush.
We install the battery in the reverse order.
We tighten the terminals of the wires on the terminals of the battery with a wrench and then apply a thin layer of plastic grease to the terminals of the wires and the terminals of the battery.
The original text can be found on the website: «ChevyMan»