Disconnect the wire terminal from the negative terminal of the battery.
Remove the generator drive belt (see Replacing the alternator drive belt) and completely unscrew the bolt securing the generator to the adjusting bar.
After pressing the connector lock, we disconnect the wiring connector from the generator.
Using a 12 mm spanner, unscrew the nut securing the wire tip to the generator's "VAT" terminal..
…and disconnect the wire.
We turn the generator around the bolts of the lower mount to the front shield.
Using a 12 mm wrench, unscrew the nuts on the generator's lower mounting bolts, holding the bolts from turning with a second 12 mm wrench.
Holding the generator, we remove the bolts..
…and we remove the generator from the engine compartment.
We install the generator in the reverse order.
At the same time, do not completely tighten the nuts and the generator mounting bolt.
We install the generator drive belt and, having adjusted its tension, finally tighten the nuts and generator mounting bolt to the prescribed torque.
The material was created based on information from the website: «ChevyMan.ru»