Vehicle Maintenance Chevrolet Lanos 1

Safety precautions during maintenance and repair
The room where repair work is being carried out must be well ventilated, the door must be easy to open both from the inside and from the outside, and the...

Location of the main units and assemblies of the car
Location of units and assemblies in the underhood space: 1 - air filter; 2 — upper support of the shock absorber strut; 3 — casing of the block of pads of...

Vehicle check
To ensure safe driving and extend the service life of the car, it is necessary to periodically conduct an external and internal inspection of the car. The...

Maintenance schedule
Mileage or duration of operation (whichever comes first) thousand km 10 20 30 40 50 60 70 80 90 100 years 1 2 3 4 5 6 7 8 9 10 Engine and its systems Engine...

Checking the condition of wheels and tires
For driving safety and to extend the service life of tires, it is necessary to visually inspect them before driving, identifying any damage that may have...

Checking the fluid level in the windshield washer reservoir
At an ambient temperature of +2°C and below, only special windshield washer fluid or concentrate diluted with water in the required proportions should be...

Replacing Windshield Wiper Blades
We replace the brushes when the quality of cleaning the windshield deteriorates, approximately once a year - preferably before the start of the autumn-winter...

Checking the oil level in the engine oil pan
We check the oil level in the oil pan on a horizontal platform with the engine not running. If the engine was running before the check, then we stop it. We...

Changing engine oil and oil filter
We change the engine oil in accordance with the maintenance regulations every 10 thousand km of run. We change it on a non-running engine, preferably...

Replacing the coolant
According to the manufacturer's maintenance regulations, the coolant should be replaced every 40 thousand km or after four years of operation - whichever comes...

Checking the level and adding oil to the gearbox
It is necessary to check the oil level in the gearbox every 10 thousand km or after a year of vehicle operation, as well as if oil leaks are detected on the...

Replacing fluid in hydraulic brake and clutch drives
We replace the working fluid in the brake and clutch hydraulic drives in accordance with the maintenance regulations - every 30 thousand km or three years...

Bleeding the hydraulic brake system
We bleed the brakes to remove air from the hydraulic drive after it has become depressurized when replacing the master cylinder, wheel brake cylinders, hoses,...

Adjusting the parking brake
The parking brake should hold the vehicle on a 23% slope. The full stroke of the parking brake drive lever should be 7–8 teeth (clicks) of the ratchet device...

Replacing the alternator drive belt
In accordance with the maintenance regulations, we replace the alternator drive belt every 60 thousand km of travel. The belt must also be replaced if cracks,...

Checking the condition and replacing the air conditioning compressor drive belt
In accordance with the maintenance regulations, we check the condition of the air conditioner compressor drive belt every 10 thousand km. There should be no...

Checking the condition and replacing spark plugs
In accordance with the maintenance regulations, we check the condition of the spark plugs during each scheduled maintenance, i.e. after 10 thousand km of run....

Replacing the fuel filter
According to the maintenance regulations, the fuel filter must be replaced every 10 thousand km. If the vehicle is operated in dusty conditions or with...

Replacing the air filter element
The replaceable air filter element must be replaced every 10 thousand km. When operating the car in dusty areas, the mileage between element replacements...

Adjusting the rear wheel bearings
We adjust the rear wheel bearings when we detect a tight rotation of the wheel or a large amount of play in the connection between the wheel journal and the...

Adjusting the direction of the headlight beams
It is recommended that adjustment of the direction of the headlight beams be carried out at a service station. Location of the light beam direction regulators...

Tightening torques for critical threaded connections
Engine Name of unit, part Tightening torque, Nm Bolt for fastening the bracket of the left support of the power unit to the gearbox housing 60 Bolt securing...

Fuels, lubricants and operating fluids used
Refueling or lubrication point Quantity, l Name of material Fuel tank 48 Unleaded motor gasoline with an octane rating of at least 92 Engine cooling system,...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: