Exterior elements of the car body Chevrolet Cruze 1

Features of the body design
The Chevrolet Cruze car body is a load-bearing structure, all-metal, four-door sedan type. The body frame includes the base, sidewalls, roof and parts...

Removal and installation mudguards
The front and rear wheel arches are fitted with plastic mudguards that protect the body from the abrasive effects of sand and stones thrown up by the wheels....

Removal and installation the front bumper
1. Open the hood and place it on the support. 2. Disconnect the wire from the negative terminal of the battery. 3. Remove the front mudguards (see " Removal...

Removal and installation the rear bumper
You will need: a flat-blade screwdriver, a TORXT20 key. 1. Remove the rear fender liners 2. Using a screwdriver, remove the two clips holding the lower bumper...

Removal and installation the front wing
You will need: a 10 mm wrench, a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front wheel arch liner...

Removal and installation the air intake box grille
You will need: a flat-blade screwdriver, a 15 mm wrench. 1. Remove the hood seal from the front shield flange. 2. Using a screwdriver, pull out the fasteners...

Removal and installation the hood
You will need a 13 mm wrench. Helpful Hint: The hood is quite heavy and bulky, so remove and install it with an assistant. 1. Open the hood and place it on the...

Removal, installation and adjustment of the hood lock and its drive
You will need: a 13 mm wrench, a flat-blade screwdriver. 1. Remove the two hood lock mounting bolts... 2. ...and remove the lock. 3. Using a screwdriver,...

Removal and installation the outside mirror
You will need a 10 mm wrench. The removal of the left exterior mirror is shown. The right mirror is removed in a similar manner. 1. Disconnect the wire from...

Windshield wiper blade replacement
This subsection describes the removal of brushes, levers and trapezoid assembly with the gear motor. 1. Move the wiper arm away from the glass, overcoming the...

Replacing windshield wiper arms
You will need: a 15 mm wrench, a flat-blade screwdriver. 1. Open the hood and place it on the support. 2. Mark on the windshield in any way (for example, with...

Removal and installation the windshield wiper mechanism
You will need a 10 mm socket head. 1. Remove the windshield wiper arms 2. Remove the air intake box grille (see " Removal and installation the air intake box...

Car body care
In order to maintain the marketable appearance of your car for as long as possible, regularly monitor the condition of the paintwork of the body and its...

Control dimensions of the body
Front of the body Engine compartment Front lower body Rear lower body Rear of the body Side of the body Front seat anchor points

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: