External body parts of cars Chevy Trailblazer 1

Car body — specifications
Tightening torques of threaded connections Nm Front rigid beam frame mounting bolts - 85 Rear Rigid Bar Frame Mounting Bolts - 363 Steering gear jumper bolts -...

General information about the car body
Warning: The vehicles described in this manual. equipped with a passive safety system (SRS), also known as an air bag system. Before carrying out work in the...

Body — maintenance
1. The general condition of the vehicle body is one of the main indicators determining its value. The body is relatively easy to service. In this case, the...

Body repair — minor damage
Plastic parts Below is a description of the procedure for removing minor scratches and chips from the surface of plastic parts. Repair of serious damage should...

Body repair — serious damage
1. Restoration of body parts after significant damage should be carried out at a station of the appropriate specialization and the appropriate level of...

Radiator grille — removal and installation
1. Open the hood and remove the plastic panel located above the radiator (see illustration). 9.1. Remove the screws and remove the radiator panel 2. When...

Hood cover — removal, installation and adjustment
Note: The hood is a heavy and bulky body part. To successfully complete this procedure, at least two people must be involved. Removal and installation 1. Cover...

Bonnet Latch and Cable — Removal and Installation
Warning: The vehicles described in this manual are equipped with a Supplemental Restraint System (SRS), also known as an air bag system. Before carrying out...

Bumpers — removal and installation
Warning: The vehicles described in this manual are equipped with a Supplemental Restraint System (SRS), also known as an air bag system. Before carrying out...

Front fenders — removal and installation
Warning: The vehicles described in this manual are equipped with a Supplemental Restraint System (SRS), also known as an air bag system. Before carrying out...

Air Intake Shroud — Removal and Installation
1. Using a wax marker, mark the original location of the wiper blades on the windshield. 2. Remove the windshield wiper arms ( see chapter 12 ). 3. Loosen the...

Mirrors — removal and installation
Exterior mirrors 1. Remove the door trim panel (see subsection 15). Remove the insulator located on the door (see illustration). 20.1 Remove the door insulator...

Airbag system — general information
1. All models covered by this manual are equipped with a supplemental restraint system (SRS), also known as an air bag system. The purpose of the system is to...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: