Brake system of the car Chevrolet Orlando 1

Anti-lock braking system
The car is equipped with an anti-lock braking system ABS (from English Anti-lock Brake System), designed to prevent wheel locking when the brake pedal is...

Vacuum brake booster
The vacuum booster is designed to reduce the force that must be applied to the brake pedal during braking. It is installed on the left side of the engine...

Checking the amplifier's functionality
A sign of a faulty brake booster is an increased force required to press the pedal for effective braking. To complete the job you will need a rubber bulb. We...

Brake pedal position sensor
The brake pedal position sensor is a potentiometer, that is, a resistor with variable resistance. Brake Pedal Position Sensor Pins Output designation Purpose...

Bleeding the brake hydraulic system
The hydraulic drive of the brake system is bled after repairs related to a breach in the tightness of the brake system and if there is a suspicion of air...

Windscreen washer — check, replacement
Windscreen washer plays an important role in ensuring road safety. Its sudden failure can cause a lot of trouble and create an emergency situation. Therefore,...

Brake fluid
Brake fluid is used in the hydraulic brake drive and in the hydraulic clutch release drive (on cars with manual transmission). In the braking system, fluid...

Replacing brake fluid
To perform the work you will need a transparent flexible tube with an internal diameter of 4-5 mm, a container for draining the brake fluid, new brake fluid...

Brake system — description and malfunctions
The car is equipped with two braking systems - service and parking. The service brake system is designed to reduce the speed of the vehicle until it comes to a...

Checking and replacing the rear brake damper
We perform the work during the inspection of the technical condition of the brake system. Note: Some vehicles do not have a damper installed. 1. We prepare the...

Brake discs
The car has ventilated disc brakes at the front and non-ventilated disc brakes at the rear. Checking brake discs We check the condition of the brake discs in...

Replacing the front brake discs
The need to replace brake discs is determined during the inspection of their technical condition (see above). Warning! Brake discs should only be replaced as a...

Replacing rear brake discs
The need to perform the work is determined during the inspection of the condition of the rear brake discs (see above). Warning! Brake discs should only be...

Checking brake pads
We check the condition of the brake pads in accordance with the maintenance plan or determine the need for such work during the diagnostics of vehicle faults....

Replacing the front brake pads
The necessity of performing this work should be determined during the inspection of the brake pads ( see above ). If the friction linings of the brake shoes...

Replacing rear brake pads
The necessity of performing this work should be determined during the inspection of the brake pads ( see above ). If the friction linings of the brake shoes...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: