We carry out the work in the following order.
1. We prepare the car for maintenance and repair.
2. Remove the cover from the master brake cylinder reservoir. We use a rubber bulb or a medical syringe to draw out as much liquid as possible from the tank.
3. Pour new brake fluid into the reservoir.
Warning! To prevent air from entering the hydraulic drive of the brake system when replacing the brake fluid, make sure that its level in the reservoir does not fall below the MIN mark.
4. Bleed the brake hydraulic system. We bleed each brake mechanism before the new one starts to come out (lighter) brake fluid from the tube, while periodically checking the fluid level and adding more.
5. After replacing the fluid in both circuits, check the brake fluid level in the master cylinder reservoir and, if necessary, bring the level up to normal. We install the lid on the tank.