Steering of car Chevy Trailblazer 1

Steering wheel — removal and installation
Warning: The vehicles described in this manual are equipped with a Supplemental Restraint System (SRS), also known as an air bag system. Before carrying out...

Steering column — removal and installation
Warning: The vehicles described in this manual are equipped with a Supplemental Restraint System (SRS), also known as an air bag system. Before carrying out...

Intermediate shaft — removal and installation
1. Park the car with its wheels facing straight ahead. Disconnect the negative battery cable. Disable the SRS system ( see chapter 12 ). 2. Turn the ignition...

Tie rod ends — removal and installation
Removal 1. Loosen the front wheel nuts, apply the parking brake, jack up the front of the vehicle and install supports. Place chocks under the rear wheels to...

Steering Gear Covers — Replacement
1. Loosen the wheel nuts, jack up the front of the car and install supports. Remove the wheels. 2. Remove the ends from the steering gear rods ( see subsection...

Steering gear — removal and installation
Warning: Do not turn the steering shaft with the gearbox removed, otherwise damage to the SRS system components may occur. To secure the shaft, it is...

Power steering pump — removal and installation
1. Disconnect the negative battery cable. 2. Remove the upper radiator fan shroud ( see chapter 3 ), as well as a serpentine drive belt ( see chapter 1 ). 3....

Power Steering Fluid Cooler — Removal and Installation
1. Remove the radiator air intake plate. 2. Place a drain pan under the front of the vehicle and disconnect the power steering hoses from the cooler (see...

Power steering hydraulic system — bleeding
1. After any procedure that involved disconnecting hydraulic lines, it is necessary to bleed the system to remove air from it and restore normal operation of...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: