Car steering Chevrolet Niva 1

Steering device
The steering device of the Chevrolet Niva is shown in Figure 5-1, 5-2, 5-3. Figure 5-1. Steering gear assembly with drive: 1 - side pull; 2 - bipod; 3 - medium...

Possible malfunctions, their causes and methods of elimination

General inspection
If there are any problems with the steering system (knocking, increased free play of the steering wheel or, conversely, its tight rotation, etc.) inspect the...

Checking the ball joints of the steering rods
First of all, check the movement of the rod ends along the axis of the pins. To do this, using a lever and support, move the end parallel to the axis of the...

Technical characteristics of the power steering mechanism
The number of revolutions of the propeller shaft when turning the bipod from stop to stop by 68° is 2.9 Gear ratio: 14.5:1 Torque on the pitman shaft at a...

Removal and installation the power steering gear
Removal: Place the vehicle on a lift and disconnect the negative wire from the battery. Loosen the nut and remove the clamping bolt securing the lower end of...

Checking and adjusting the power steering mechanism
Check: Secure the steering gear in a vice with soft jaws. Set the steering gear to the middle position, dividing the full angle of rotation of the propeller...

Technical characteristics of the power steering pump
The pressure developed by the pump (MPa) is 10±4 Pump capacity (l/min) — 6±0.75 Working fluid - oil "Pentosin Hidraulik Fluid CHF11S"

Checking the power steering pump characteristics
Remove oil from tank 9 (see figure 5-3) power steering. Figure 5-3. Power steering system: 1 - Power steering oil pump; 2 - heat exchanger; 3 - gasket...

Removal and installation the power steering pump
Removal: Place the vehicle on a lift and disconnect the negative wire from the battery. Remove oil from tank 9 (see figure 5-3) power steering. Figure 5-3....

Removal and installation the steering shaft with bracket
Removal. Perform the following operations: lift the hood of the car. Unscrew the nut and remove the clamping bolt securing the lower end of the intermediate...

Steering linkage rods and ball joints
Removal and installation Removal. Unscrew the cotter pins and nuts that secure the ball joints of the side rods to the levers 9 (see figure 5-1) on the...

Pendulum lever with bracket
Removal and disassembly. Unpin the nuts securing the ball joints to the pendulum arm, unscrew the nuts. Use a puller to remove the ball joints from the lever...

Removal and installation the steering wheel for the 55 configuration
Removing the horn cover Figure 5-7. Steering wheel: 1 - horn cover; 2 - steering wheel. Remove cover 1 (figure 5-7) sound signal, overcoming the resistance of...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: