Car engine lubrication system Chevrolet Niva 1

Oil pump drive device
The oil pump drive device is shown in Figure 2-67. Figure 2-67. Oil pump drive: 1 - chain; 2 - front bearing; 3 - oil pump drive shaft; 4 - rear bearing; 5 -...

Oil change
The oil must be changed on a warm engine. To completely drain the oil, you must wait at least 10 minutes after opening the drain hole. When changing the oil,...

Determining oil consumption
Determination of the actual value of the specific consumption of engine oil for burning is carried out over a mileage of 200-300 km. The car must be in good...

Oil pump
The main dimensions of the pump parts and its drive are shown in Figure 2-68. Removal and installation. If only the oil pump needs to be repaired, remove the...

Oil pump drive shaft and gears
There should be no dents or scratches on the surfaces of the roller support journals and on the working surface of the eccentric. The teeth of the gears of the...

Engine crankcase ventilation system
Forced ventilation is used to remove gases and gasoline vapors from the crankcase, which is carried out by sucking gases from the crankcase into the engine...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See similar sections on Chevrolet cars:
Power unit: Lubrication system Chevrolet Aveo T300 (2012-2018)
Power unit: Lubrication system Chevrolet Cruze 1 (2008-2016)

Share information: