Car steering Chevrolet Tahoe 1

Tightening torques for connections (Nm)
Steering gear shaft mounting nut - 220 Steering knuckle to steering rod mounting nut - 50 Main steering rod to pendulum arm mounting nut - 50 Nut securing the...

Steering wheel — removal and installation
Caution! When working near the steering column, turn off the airbag ( see Chapter 12 ). 1. Disconnect both cables from the battery. 2. On pre-1994 models, pry...

Steering rods — inspection, removal and installation
1. The steering rods connect the steering mechanism to the front wheels and ensure that the relative position of the wheels is maintained (see photo). The...

Steering gear — removal and installation
Caution! On models equipped with an airbag, do not rotate the steering column shaft with the steering gear removed, otherwise the airbag module will be...

Power steering pump — removal and installation
1. Disconnect the battery from ground. 2. Remove the drive belt. 3. Press the power steering pump pulley off the pump shaft using a puller (see photo). 4....

Power Steering — Bleeding
1. It is necessary to remove air from the hydraulic steering drive whenever the line is disassembled, regardless of the measures taken to prevent air from...

Front wheel alignment angles
Wheel alignment, steering axis tilt angle and wheel toe-in are subject to adjustment (see photo). Wheel alignment angles are recommended to be checked and...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)