Car steering Chevrolet Aveo 2 (T300)

Features of the steering design
All Chevrolet Aveo models are equipped with hydraulic power steering, a trauma-safe steering column, adjustable for reach and tilt angle (in LS trim - only by...

Possible steering malfunctions, their causes and solutions

Inspection and testing of the steering system on the car
Check the condition of the steering regularly, as driving safety depends on it. When inspecting the steering, pay special attention to the condition of the...

Checking the free play (play) of the steering wheel
With increased free play of the steering wheel, it is difficult to control the car, as it reacts to the driver's actions with a delay. In addition, increased...

Removal and installation the steering wheel
You will need a TORX T50 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Set the steering wheel to a position corresponding to the...

Removal and installation the steering column cover
You will need: a Phillips-head screwdriver and a plastic mounting spatula. 1. Turn the steering wheel to the left enough to access the left upper screw...

Removal and installation the steering column
You will need: socket heads "11", "13", a flat-blade screwdriver, pliers. The steering column is one of the most important elements of road safety, so replace...

Replacing the outer tie rod end
You will need: keys "8", "13", "18", "19", "21", ball joint puller. NOTE: It is more convenient to perform the work on a lift. It can also be performed on a...

Replacing the steering rod protective boot
You will need: spanners "8", "13", "18", "19", "21", a lug wrench, a ball joint puller, pliers, side cutters. NOTE: The right and left tie rod covers are...

Replacing the steering rod
You will need: wrenches "8", "13", "18", "19", "21", "22", "32", a lug wrench, a ball joint puller, pliers, side cutters. NOTE: The right and left tie rods are...

Bleeding the power steering system
Pumping (air removal) hydraulic power steering system is required after any work involving depressurization of the system (replacement of pump or pipelines). A...

Replacing the working fluid in the power steering system
You will need: a syringe or rubber bulb, pliers, a container to collect the liquid. According to the manufacturer's recommendation, the fluid in the power...

Removal and installation the power steering reservoir
You will need: a syringe or rubber bulb, pliers. 1. Remove the plug and pump out the working fluid from the power steering reservoir (see " Replacing the...

Replacing the power steering pump
You will need: a 16 mm wrench, a 13 mm socket head, pliers, and a container for draining the working fluid from the tank. 1. Remove the power steering pump...

Replacing the steering gear
You will need: 18 mm keys and TORX E18. The steering mechanism is removed for repair or replacement. However, keep in mind that the steering mechanism is the...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: