Vehicle Security Systems Chevrolet Aveo 2 (T300)

Design features of the passive safety system (SRS)
The passive safety system (SRS) of the Chevrolet Aveo includes front airbags for the driver 1 (figure 13.1) and passenger 2 in the front seat and inertia seat...

Removal and installation the driver's airbag
You will need: two rods 150-170 mm long, 4-5 mm in diameter, a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery....

Removal and installation the front passenger airbag
You will need: 7 and 10 mm socket heads, flat and Phillips-head screwdrivers, and a plastic mounting blade. 1. Disconnect the wire from the negative terminal...

Removal and installation the driver's airbag contact ring
You will need: TORX T20 and TORX T50 keys, flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2....

Removal and installation front seat belts
You will need: a 10 mm socket head, a TORX T50 key, a flat-blade screwdriver, and a plastic mounting blade. The driver's and front passenger's seat belts are...

Removal and installation rear seat belts
You will need: 18 mm keys, TORX T50, flat-blade screwdriver. The rear central seat belt reel is located inside the right side of the rear seat back. Therefore,...

Removal and installation of the electronic control unit of the passive safety system
You will need: a 10 mm socket wrench and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Using a screwdriver,...

Removal and installation the driver's airbag control unit
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front seat (see "...

Removal and installation the shock sensor
You will need: TORX E5 key, flat-blade screwdriver. NOTE: Operation is shown using the front impact sensor as an example. On a vehicle equipped with side...

Removal and installation the front passenger airbag switch
You will need: a special plastic mounting spatula, flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery....

Design features of the anti-lock braking system (ABS)
The anti-lock braking system (ABS) consists of wheel speed sensors, a switch on the brake pedal, a hydro-electronic control module and a warning lamp in the...

Removal and installation front wheel speed sensors
You will need: tools for removing the wheel, a 5 mm Allen key, a flat-blade screwdriver. The front wheel speed sensor is installed in the hole of the front...

Removal and installation rear wheel speed sensors
You will need: tools for removing the wheel, a 10 mm wrench, a 5 mm Allen key, and a flat-blade screwdriver. The rear wheel speed sensor is installed in the...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See similar sections on Chevrolet cars:
Body: Security systems Chevrolet Cruze 1 (2008-2016)

Share information: