Car Clutch Repair Chevrolet Aveo 1.5 (T250)

General information about the clutch
Technical specifications Type Single disc dry Outer diameter 215 mm Inner diameter 145 mm Thickness 8.4 mm Liquid used DOT 4 brake fluid Leading elements The...

Clutch pedal — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Disconnect the return spring from the clutch pedal. 3. Remove the nut, washer and pedal axle. 4. Remove...

Adjusting the clutch pedal (hydraulic drive)
1. Determine the pedal's free play. Press the pedal lightly with your hand and measure the distance to the point where you feel resistance. 2. Adjust the pedal...

Adjusting the clutch release moment
1. Pull the handbrake handle. 2. Start the engine at idle speed. 3. When moving the gearshift lever to the reverse position, slowly release the clutch pedal...

Bleeding air from the hydraulic drive
Bleed any air from the hydraulic system that was introduced when the lines were disconnected for repair. The fluid level in the clutch/brake reservoir should...

Removal, checking and installation the pressure plate and driven disk
Removal 1. Disconnect the negative battery cable. 2. Remove the gearbox. 3. Remove the pressure plate mounting screws and the pressure plate. Caution: When...

Removal and installation the clutch master cylinder
Removal Caution: Before disconnecting the reservoir tank hose, remove the liquid from the expansion tank. 1. Remove the locking bracket. 2. Remove the push rod...

Removal and installation the clutch slave cylinder
Removal 1. Loosen the bolt and disconnect the hose from the clutch release cylinder. 2. Remove the clutch release slave cylinder mounting screws and remove the...

Disassembly and assembly of the clutch master cylinder
Disassembly 1. Remove the clutch master cylinder. 2. Remove the dust cover and disconnect the piston retaining ring. 3. Remove the pusher and piston. 4. Check...

Disassembly and assembly of the clutch slave cylinder
Disassembly 1. Remove the clutch slave cylinder. 2. Remove the dust cover and pusher. 3. Press the piston, then remove the retaining ring with round-nose...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: