Car Clutch Repair Chevrolet Captiva 1

General description and operation of the clutch
Leading parts The leading elements of the design are two flat surfaces, machined and ground. One of them is the rear surface of the engine flywheel, and the...

Tightening torques for threaded connections
Tightening torques for threaded connections Range Nm Pound foot Pound-inch Pedal axle nut 18 13 - Clutch Master Cylinder Nuts 23 17 - Concentric Clutch Release...

Diagnosing Clutch Faults
Clutch jerks Checks Operation, action Make sure the driver uses the clutch correctly. Explain to the driver how to use the clutch correctly. Check the oil...

Hydraulic clutch components
1. Clutch pedal 2. Locking bracket 3. Insert 4. Clutch pedal position sensor 5. Clutch pedal bracket 6. Clutch pedal axle 7. Screw 8. Return spring 9. Clutch...

Clutch pedal — removal and installation
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the nut and pedal axle. 3. Disconnect the return spring from the...

Clutch pedal position sensor
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Disconnect the switch connector. 3. Remove the clutch pedal position...

Bleeding the Clutch Hydraulic Drive
This procedure is designed to remove air that has entered the system after disconnecting the hydraulic drive tubes during repairs. The level of fluid for the...

Pressure plate and clutch disc (FAM II 2.4D)
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the gearbox from the vehicle. See Section 5B, "Five-Speed Manual...

Pressure Plate and Clutch Disc (2.0S Diesel or HFV6 3.2L)
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the gearbox from the vehicle. See Section 5B, "Five-Speed Manual...

Clutch master cylinder assembly
Removal procedure Before disconnecting the hose from the clutch hydraulic system reservoir, the fluid should be drained from the reservoir. 1. Remove the...

Concentric working cylinder
Removal procedure 1. Remove the gearbox from the vehicle. See Section 5B, "Five-Speed Manual Transmission". 2. Remove the bolts securing the concentric clutch...

Clutch Master Cylinder — Disassembly and Assembly
Disassembly procedure 1. Remove the clutch master cylinder assembly from the vehicle. See "Clutch Master Cylinder Assembly" in this section. 2. Remove the...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1 (2006-2018)