2.0L diesel engine electrical equipment Chevrolet Captiva 1

General description and operation of electrical equipment
Battery All cars have standard sealed batteries. There are no ventilation plugs in the cover. The battery is completely sealed, except for two small...

Technical characteristics of electrical equipment
Starter specifications Application Unit Description Type - PG260NS Performance (power) kW 1.8 kW No-load test at 12 volts A 90 max. Speed of rotation of the...

Schematic and assembly diagrams of starting and charging
Engine starting system Charging system

Diagnostics of engine electrical equipment
Electrical equipment STATE Probable cause Elimination The crankshaft does not turn Low battery voltage. Charging or replacing the battery. The battery cable is...

Checking the battery under load
1. Check the battery for visible damage, such as a broken case or cover, which may cause electrolyte loss. If there is visible damage, replace the battery....

Checking the generator output power
1. Perform a generator system check. See "Checking the Generator System" in this section. 2. Replace the generator if the test results are negative. See...

Checking the generator system
During normal operation, the generator indicator light comes on when the ignition switch is in the on position and goes out when the engine is started. If the...

Starter noise
Start the engine. If the starter is not working properly, you can correct it as follows. Before you perform the following steps, make sure the battery is fully...

Removal and installation the generator
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the decorative cover. See Section 1B, "Engine Mechanical System...

Removal and installation the starter
Removal procedure 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the lower engine shield. Follow section 9N, Frame and Underbody....

Battery pack and battery shelf
Removal procedure 1. Disconnect the wire from the negative battery terminal, and then disconnect the wire from the positive battery terminal. 2. Unscrew the...

Disassembling and assembling the starter
Disassembly procedure 1. Remove the starter. Follow step "Starter" in this section. 2. Remove the starter through-bolts. 3. Remove the commutator end piece and...

Disassembly and assembly of the generator
Disassembly procedure 1. Remove the generator. Follow the step "Generator" Car maintenance in this section. 2. Make markings on the end face to facilitate...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1 (2006-2018)