Diagnostics of engine electrical equipment The starter does not turn the engine Checkpoints Operation, action Low battery voltage Charging or replacing the battery. The battery cable is loose, rusty or...
Starter noise Start the engine. If the starter is not working properly, you can correct it as follows. Before you perform the following steps, make sure the battery is fully...
Checking the battery under load 1. Check the battery for visible damage, such as a broken case or cover, which may cause electrolyte loss. If there is visible damage, replace the battery....
Checking the generator output power 1. Perform a generator systems check. Follow step "Checking Generator Systems" in this section. 2. Replace the alternator if it fails the test. Follow step...
Checking generator systems During normal operation, the generator indicator light comes on when the ignition is in the RUN position and goes out when the engine is started. If the light...
Removal and installation the generator Removal procedure 1. Disconnect the negative battery cable. 2. Remove the engine trim cover. See section 1C2, Engine Mechanical - HFV6 3.2L. 3. Remove the air...
Removal and installation the starter Removal procedure 1. Disconnect the negative battery cable. 2. Remove the front exhaust pipe. See section 1G3, Engine Exhaust System - HFV6 3.2L. 3. Remove the...
Battery pack and battery shelf Removal procedure 1. Disconnect the cable from the negative battery terminal, and then disconnect the cable from the positive battery terminal. 2. Unscrew the...
Disassembling and assembling the starter Disassembly procedure 1. Remove the starter. Follow step "Starter" in this section. 2. Remove the starter through-bolts. 3. Remove the commutator end piece and...
Disassembly and assembly of the generator Disassembly procedure 1. Remove the generator. Follow the step "Generator" Car maintenance in this section. 2. Make markings on the end face to facilitate...