Clutch pedal position sensor (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Disconnect the cable from the negative terminal of the battery.

2. Disconnect the switch connector.

3. Remove the clutch pedal position sensor.

Installation procedure

1. Install the clutch pedal position sensor.

2. Connect the switch connector.

3. Connect the cable to the negative terminal of the battery.

(The source of the article is available on the website ChevyMan.ru)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Clutch

Clutch pedal — removal and installation
Hydraulic clutch components
Diagnosing Clutch Faults
Tightening torques for threaded connections
General description and operation of the clutch

Bleeding the Clutch Hydraulic Drive
Pressure plate and clutch disc (FAM II 2.4D)
Pressure Plate and Clutch Disc (2.0S Diesel or HFV6 3.2L)
Clutch master cylinder assembly
Concentric working cylinder

See similar articles on the topic of Chevrolet cars:
Checking the Clutch Release Pedal Travel Chevrolet Aveo T300 (2012-2018)
Scheme 24. Steering wheel angular displacement sensors, accelerator pedal position sensors and ABS hydro-electronic module Chevrolet Cruze 1 (2008-2016)
Removal the crankshaft position sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Clutch and brake pedal bracket Chevrolet Niva 1 (2002-2016)
Accelerator pedal position sensor Chevrolet Tahoe 2 and 3 (2000-2014)
Clutch Pedal Position Sensor Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)