Car manual transmission Chevrolet Aveo 2 (T300)

Features of the design of a mechanical gearbox
The cars are equipped with a five-speed manual transmission mod. F17-5 (figure 6.3). The manual gearbox is a two-shaft design with five synchronized forward...

Possible malfunctions of a manual gearbox, their causes and methods of elimination

Checking the level, topping up and changing the oil
You will need: socket heads "13", "17", syringe. Periodically (but not less than once every 15,000 km) check the oil level in the manual transmission. The...

Replacing the seals of the manual transmission
You will need: a mounting blade, a large screwdriver, a hammer, and a mandrel. To replace the inner constant velocity joint (CV) seals, drain the oil from the...

Removal and installation of a manual transmission
You will need: keys "14", "18", TORX E18, a screwdriver with a flat blade. The main faults that require removing the manual transmission from the vehicle to...

Removal and installation the gearshift lever linkage for a manual transmission
You will need: a 10 mm socket head and a flat-blade screwdriver. 1. Remove the floor tunnel lining (see " Removal and installation the floor tunnel lining ")....

Replacing manual transmission control cables
You will need a flat-blade screwdriver. 1. Remove the floor tunnel lining (see " Removal and installation the floor tunnel lining "). 2. Pry it off with a...
There is 1 comment

Adjusting the manual transmission control drive
No tools are required to adjust the manual transmission control drive. The manual transmission control drive consists of two cables: gear selection and gear...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: