Car heating system Chevrolet Aveo 2 (T300)

Features of the heating system
The heating, air conditioning and ventilation system is a single complex that provides the most comfortable conditions in the car regardless of weather...

Features of the air conditioning system
Chevrolet Aveo cars are equipped with a compressor-type air conditioning system. The heater units and the air conditioner evaporator heat exchanger are...

Features of the ventilation system
The car uses a supply and exhaust ventilation system. Outside air can enter the passenger compartment through the door windows when the windows are down......

Safety rules for repair and maintenance of air conditioning systems
1. The refrigerant is a chemical compound that requires careful handling to avoid causing harm to health. 2. It is necessary to work in a well-ventilated area...

Removal refrigerant from the air conditioning system
Before performing work involving depressurization of the air conditioning system, remove the refrigerant from the system. 1. Unscrew the threaded cap of either...

Replacing sealing rings
WARNING: Although the O-rings may look identical on the outside, only use the O-rings that are recommended for air conditioning systems. Otherwise, there may...

Features of air conditioning compressor operation
An air conditioner compressor is a fairly complex, high-tech unit. Some units of the compressor pump section are manufactured using selective assembly, so...

Removal and installation the air conditioning compressor
You will need a 13 mm wrench. 1. Remove the refrigerant from the air conditioning system (see " Removal refrigerant from the air conditioning system "). 2....

Replacing the air conditioner condenser
You will need: an 8 mm socket head, a 13 mm wrench, and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove...

Replacing the filter element of the receiver-dryer
You will need: flat- and Phillips-head screwdrivers, TORX keys T20, T25, T45, T50, a 16 mm socket head, pliers, and a snap ring puller. When repairing or...
There is 2 commentary

Replacing the pressure sensor in the air conditioning system
You will need a 14 mm wrench. The sensor is screwed onto the threaded fitting of the pipeline flange through a shut-off valve, so when removing the sensor for...

Replacing the outside temperature sensor
No tools are required to replace the sensor. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the crankcase guard... 3. ...and the...

Removal and installation the control unit for the heating, air conditioning and ventilation system
You will need: a 7 mm socket head, flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the...

Replacing the cabin air filter
No tools are required to replace the cabin air filter. To clean the air supplied to the passenger compartment from dust contained in the outside air, a filter...

Removal and installation the heater electric fan resistor
You will need: 5.5" and 7" socket heads. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the three screws securing the right...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: