Internal elements of the car body Chevrolet Aveo 2 (T300)

Removal and installation the front seat
You will need: 10 mm and TORX T50 keys, a plastic mounting blade or a flat-blade screwdriver. NOTE: The work is shown for the left seat, the right seat is...

Removal and installation the rear seat
You will need a flat-blade screwdriver. 1. Pull the front edge of the rear seat cushion and release the cushion mounting loops from the clips. 2. Lift the rear...

Removal and installation the floor tunnel lining
You will need: a 7 mm socket head, a plastic mounting blade, and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2....

Removal and installation the interior rearview mirror
You will need a TORX T35 key. 1. Remove the screw securing the interior rearview mirror. 2. Remove the mirror by sliding it up along the guides of the bracket...

Features of the instrument panel design
The instrument panel is installed on the car (figure 11.4) a collapsible structure consisting of a metal power frame, a plastic decorative frame and decorative...

Removal and installation storage boxes
To remove the lower storage compartment, follow these steps. You will need pliers. 1. Open the lower glove compartment and remove the damper rod eye from the...

Removal and installation the lower decorative panel of the instrument panel
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the two screws securing...

Removal and installation decorative instrument panel trims
You will need: socket heads "7", "10", screwdrivers with flat and Phillips blades, a plastic mounting blade. 1. Disconnect the wire from the negative terminal...

Replacing handrails
You will need: an 8 mm socket head and a flat-blade screwdriver. 1. Pry up and remove the handrail mounting bolt caps. 2. Unscrew the mounting bolts... 3....

Replacing sun visors
You will need: TORX T15 key, flat-blade screwdriver. 1. Disengage the visor eye from the holder. 2. Remove the two screws securing the visor bracket to the...

Removal and installation of interior trim
You will need: a 10 mm wrench, a plastic mounting blade. NOTE: Shown are the removal and installation of trims on the left side of the vehicle interior. The...

Removal and installation trunk trims
You will need: a 10 mm wrench, flat-head and Phillips-head screwdrivers. 1. Pull out the cores of the four pins securing the rear trim panel of the trunk. 2....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: