Internal elements of the car body Chevrolet Cruze 1

Removal and installation the front seat
You will need: TORX T50 and "10" keys. Note: The work is shown for the left seat, the right seat is removed in the same way. 1. Disconnect the wire from the...

Removal and installation the rear seat
The rear seat cushion is one piece and can be removed as a whole. The rear seat back consists of two parts, each of which can be removed separately. The left...

Removal and installation the floor tunnel lining
The floor tunnel lining consists of four parts: the lining itself, two panels (left and right) and decorative overlay. You will need: a 7 mm spanner and a...

Removal and installation the interior mirror
You will need a TORX T25 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Overcoming the elastic resistance of the clamps, move the...

Replacing handrails
You will need: a flat-blade screwdriver, a 7 mm wrench. 1. Fold the handrail down. 2. Use a screwdriver to pry... 3. ...and remove the decorative caps from the...

Features of the instrument panel design
Fig. 11.1. Instrument panel: 1 - control unit for headlight corrector and instrument cluster illumination brightness; 2 - lower instrument panel trim; 3 -...

Removal and installation the instrument panel
You will need: socket heads "10", "12", a screwdriver with a flat blade. The dashboard frame is equipped with a large number of wiring harnesses for various...

Removal and installation of interior trim
You will need: a flat-blade screwdriver, a 10 mm wrench. 1. Overcoming the resistance of spring holders. 2. ...remove the front pillar trim. 3. Squeeze the...

Removal and installation trunk trims
You will need: flat-head and Phillips-head screwdrivers. 1. Open the trunk lid. 2. Lift the spare wheel well cover... 3. ...and take it off. 4. Using a...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: