Vehicle exhaust system Chevrolet Cruze 1

Design features of the exhaust system
Fig. 5.17. Exhaust system components: 1 - intake pipe; 2 - exhaust manifold heat shield; 3 - diagnostic oxygen concentration sensor; 4 - exhaust manifold...

Replacing the exhaust system suspension cushions
The rubber mounts of the exhaust system suspension are replaced if, due to damage or excessive deformation, the system elements begin to knock when in contact...

Replacing the exhaust manifold
You will need: a 22 mm wrench, 12 mm and 14 mm socket wrenches. 1. Remove the decorative engine cover (see " Removal and installation the decorative engine...

Removal and installation the catalytic converter
You will need: open-end wrench and socket wrench "14". 1. Remove the bolt securing the intake pipe support bracket to the cylinder block. 2. Unscrew the nut...

Replacing the inlet pipe
You will need: a 14 mm socket wrench and a flat-blade screwdriver. 1. Press the lock... 2. ...and disconnect the oxygen sensor diagnostic harness connector...

Replacing the main and additional mufflers
The main and additional mufflers are made as a single element. You will need: a 14 mm wrench, a flat-blade screwdriver. 1. Remove the fuel tank from the...

Removal and installation of thermal screens
During engine operation, the exhaust system heats up to a high temperature, so if there is severe mechanical damage or significant corrosion of the heat...

Exhaust gas recirculation system
The exhaust gas recirculation system serves to reduce exhaust toxicity (by reducing the formation of nitrogen oxides). At high combustion temperatures of the...

Removal and installation the exhaust gas recirculation valve
You will need the key "on 12" (better end). 1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch. 4. ...and disconnect the...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: