Car front suspension Chevrolet Cruze 1

Features of the front suspension design
The front suspension is independent, lever-spring type MacPherson, with telescopic shock absorber struts, coil springs, lower wishbones and anti-roll bar. The...

Possible faults of the front suspension, their causes and methods of elimination
Cause of malfunction Method of elimination Noise and knocking when the car is moving Loosening of the brackets of the vehicle's anti-roll bar to the body and...

Checking the technical condition of the front suspension parts on the car
All checks and work should be carried out in the engine compartment or from underneath the vehicle, installed on a lift or inspection pit (with front wheels...

Removal and installation the front suspension shock absorber
You will need: keys "18", "24", TORX T50, T40, a key for wheel nuts. 1. Apply the parking brake to the vehicle... 2. ...and install wheel chocks ("shoes")...

Repair of the front suspension shock absorber
The shock absorber strut parts are shown in Fig. 7.2. Fig. 7.2. Shock absorber strut parts: 1 - Upper mount nut cap; 2 - shock absorber strut upper mounting...

Replacing the upper support of the front suspension shock absorber strut
To replace the upper shock absorber strut support, you must remove the strut from the vehicle (see " Removal and installation the front suspension shock...

Replacing the front suspension ball joint
The original lower front suspension arms are assembled with a ball joint, so the ball joint can only be replaced together with the arm (see " Replacing the...

Replacing the front suspension arm
You will need: 15 and 18 mm wrenches, a flat-blade screwdriver. 1. Raise both sides of the front of the vehicle and support it securely. 2. Remove the wheel....

Replacing the front suspension stabilizer bar
You will need: keys "14", "18", TORXT40. 1. Apply the parking brake to the vehicle. 2. Place wheel chocks ("shoes") under the rear wheels. 3. Raise the front...

Replacing the front suspension stabilizer bar
You will need: keys required to remove the front suspension subframe. 1. Disconnect the wire from the negative terminal of the battery. 2. Loosen the wheel...

Removal and installation the front suspension steering knuckle
You will need: keys "8", "15", "18", "32", TORX T30, a flat-blade screwdriver, a hammer, a punch, a ball joint puller. 1. Loosen the wheel nut. 2. Using a...

Removal and installation the front suspension subframe
1. Disconnect the wire from the negative terminal of the battery. 2. Set the steering wheel to the straight-ahead position. 3. In the passenger compartment,...

Checking and adjusting wheel alignment angles
Checking and adjusting the wheel alignment angles is necessary to ensure good stability and control of the vehicle, as well as uniform wear of the tires during...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: