Power electrical devices of the car Chevrolet Cruze 1

Features of the battery design
Fig. 10.3. Battery structure: 1 - monoblock (body); 2 - partition of elements; 3 - density indicator float; 4 - terminal "minus"; 5 - common cover; 6 -...

Battery care
At least once every two weeks, remove dust and dirt from the surface of the monoblock and battery cover with a dry cloth. If electrolyte accidentally appears...

Possible faults of the battery
Possible battery malfunctions, their causes and solutions Cause of malfunction Method of elimination Battery discharge during vehicle operation Accessory drive...

Checking the battery charge level
If during operation there are difficulties with starting the engine, check the state of charge of the battery by the density of the electrolyte or the voltage...

Charging the battery
After removing the battery from the vehicle, carefully clean it, especially the top part (see " Battery Care "), check the electrolyte level and, if necessary,...

Removal and installation the battery
You will need: keys "10" and "13". The battery is located in the engine compartment on the left. 1. Pull the hood release handle and open the hood. 2. Loosen...

Features of the generator design
Chevrolet Cruze cars are equipped with a three-phase alternating current generator, with a built-in rectifier unit and an electronic voltage regulator,...

Possible generator faults
Possible generator malfunctions, their causes and methods of elimination Cause of malfunction Method of elimination When the ignition is turned on, the low...

Removal and installation the generator
You will need: keys "10", "12" and "14". 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the decorative engine cover (see " Removal...

Replacing the generator pulley
You will need: a 24 mm wrench, an 8 mm Allen key, a welding clamp or sliding cobra pliers. 1. Remove the generator from the vehicle (see " Removal and...

Generator repair
You will need: TORX keys E4 and E8, hammer, extension, ratchet, soldering iron, tester, mandrels, pullers for covers and rotor bearings. 1. Remove the...

Features of the starter design
The Chevrolet Cruze starter is a four-pole, four-brush DC electric motor with excitation from permanent magnets, combined with a planetary gearbox and an...

Possible starter malfunctions
Possible starter malfunctions, their causes and solutions Cause of malfunction Method of elimination When the starter is turned on, the anchor does not rotate,...

Removal and installation the starter
The starter is mounted on the cylinder block at the rear of the power unit. You will need; keys "10", "12" and "13". 1. Disconnect the wire from the negative...

Starter repair
Before disassembling the starter, make sure it is in good working order by performing the following simple checks. 1. Using a screwdriver, check the ease of...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: