Car gearbox Chevrolet Cruze 1

Features of the gearbox design
Chevrolet Cruze cars are equipped with a five-speed manual (mod. D16) or a six-speed automatic (mod. 6T30/6T40/6T45) gearbox. Manual transmission (fig. 6.4,...

Possible malfunctions of a manual gearbox, their causes and methods of elimination
Cause of malfunction Method of elimination Vibration, noise in the gearbox Loose or damaged engine mounts and gearboxes Tighten the fasteners or replace the...

Automatic transmission diagnostics
There are several operations and testing tests for earlier and more accurate detection of the fault. However, we strongly recommend not to abuse them and to...

Checking the level, topping up and replacing oil in a manual transmission
Periodically (but not less than every 15,000 km) check the oil level in the manual gearbox. The design of the gearbox does not provide for oil changes...

Checking the level and adding working fluid to the automatic transmission
Periodically (but not less than every 15,000 km) check the level of the working fluid in the automatic transmission. The design of the transmission does not...

Replacing gearbox drive seals
The inner CV joint seals can be replaced without removing the gearbox from the vehicle. The procedure for replacing the inner CV joint seals of manual and...

Removal and installation of a manual gearbox
The main faults that require removing the manual transmission from the vehicle to fix are: elevated (compared to the usual) noise: difficult gear shifting;...

Disassembly, assembly of gearbox, defect detection of parts
You will need: 10, 13, 19, 24 keys, a set of Allen keys, flat-blade screwdrivers (two), round-nose pliers, a snap ring puller, a bearing puller, a hammer, a...

Secondary shaft repair
You will need: a snap ring plier, a screwdriver, round-nose pliers, a universal puller. 1. Press the rear bearing off the secondary shaft... 2. ...and take it...

Primary shaft repair
You will need: TORX M8 key, snap ring puller, universal puller. 1. Use a puller to compress the primary shaft retaining ring... 2. ...and remove it from the...

Gearbox synchronizer repair
If the gear engages unclearly or with great effort or does not engage at all, before disassembling the secondary shaft, check the operation of the...

Gearbox differential repair
One of the reasons for increased noise in the gearbox may be wear or breakage of differential parts. You will need: a 15 mm spanner, a universal puller, a...

Replacing manual transmission control cables
You will need: pliers, a flat-blade screwdriver. To remove the manual transmission control cables, follow these steps:. 1. Disconnect the rear cable ends from...

Removal and installation the gearbox control lever joint
You will need: 10 and 12 mm wrenches, a flat-blade screwdriver. 1. Overcoming the force of the clamps, remove the lever cover together with the frame. 2....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: