Vehicle lighting and alarm Chevrolet Cruze 1

Lighting, light and sound signaling
Headlights Chevrolet Cruze cars use headlights that combine low and high beams, parking lights and direction indicators. The headlights use the so-called...

Possible malfunctions of lighting and light signaling
Possible malfunctions of lighting and light signaling, their causes and methods of elimination Cause of malfunction Method of elimination Some headlights and...

Checking and adjusting headlights
Check and adjust the headlights on a loaded vehicle (with a full fuel tank, tool kit and spare tire). The method described in this subsection, using the marked...

Replacing lamps
You will need: flat-head and Phillips-head screwdrivers. Warning: Before replacing bulbs in vehicle lighting devices, disconnect the wire from the negative...

Headlight replacement
You will need: a 7 mm spanner and a flat-blade screwdriver. Note: Shown is the removal of the right headlight. The left headlight is removed in a similar...

Replacing the rear light located on the wing
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the side trim of the trunk...

Removal and installation the rear light located on the trunk lid
You will need an 8 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the trunk lid trim (see " Removal and installation...

Replacing an additional brake light
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Fold down the rear seat back. 3....

Replacing the side turn signal
1. Disconnect the wire from the negative terminal of the battery. 2. Slide the light back... 3. ...and, overcoming the resistance of the spring retainer,...

Replacing steering column switches
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the steering wheel (see " Removal and installation the steering wheel "). 3. Remove...

Replacing the sound signal
The horn is mounted on a bracket behind the front bumper. You will need a 10 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: