Replacing the rear light located on the wing (Chevrolet Cruze J300)

You will need: flat-head and Phillips-head screwdrivers.

1. Disconnect the wire from the negative terminal of the battery.



2. Remove the side trim of the trunk on the side of the light being removed (see "Removal and installation trunk trims").



3. Disconnect the rear light wiring harness connector.



4. Use a screwdriver to pry...





5. ...and move aside the screw covers for the rear light.



6. Remove the two screws securing the light to the body.



7. Push the rubber seal into the wiring harness hole in the vehicle body.



8. Pull the tail light wiring harness through the opening in the body.





9. Remove the rear light from the vehicle.

10. Install the light in the reverse order of removal.