Removal and installation the rear light located on the trunk lid (Chevrolet Cruze J300)

You will need an 8 mm wrench.

1. Disconnect the wire from the negative terminal of the battery.

2. Remove the trunk lid trim (see "Removal and installation the trunk lid trim").

3. Disconnect the rear light wiring harness connector.

4. Unscrew the nuts securing the light.

5. Remove the rear light located on the trunk lid from the vehicle.

6. Install the light in the reverse order of removal.

[The article was borrowed from the website «ChevyMan»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Cruze 1: Lighting and signaling

Replacing the rear light located on the wing
Headlight replacement
Replacing lamps
Checking and adjusting headlights
Possible malfunctions of lighting and light signaling

Replacing an additional brake light
Replacing the side turn signal
Replacing steering column switches
Replacing the sound signal

See similar articles on the topic of Chevrolet cars:
Replacing the bulbs in the rear light Chevrolet Aveo T300 (2012-2018)
Front and rear fog light circuit Chevrolet Captiva 1 (2006-2018)
Replacing the bulbs in the rear light, removing the light Chevrolet Lacetti 1 (2002-2009)
Wiring diagram for fog lights and fog light bulb in left rear light Chevrolet Lanos T150 (2002-2009)
Rear fog lights on/off control Chevrolet Niva 1 (2002-2016)
Removal and installation the rear interior light Chevrolet Tahoe 2 and 3 (2000-2014)
Front fog lights, rear fog light Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet