1. Overcoming the resistance of spring holders.
2. ...remove the front pillar trim.
3. Squeeze the retainer to disconnect the wiring harness connector from the high-frequency speaker and remove the trim.
4. Pull the front door sill trim...
5. ...and remove it, overcoming the resistance of the spring holders.
6. Bend back the rubber seal of the rear door.
7. Pull the rear door sill trim...
8. ...and remove it, overcoming the resistance of the holders.
9. Overcoming the resistance of the holders.
10. ... remove the lower part of the B-pillar trim.
For clarity, removal of the lower part of the B-pillar trim is shown with the driver's seat removed.
11. Disconnect the driver's lower seat belt anchor.
12. Remove the upper part of the B-pillar trim, overcoming the resistance of its clips.
13. Pass the seat belt buckle tongue through the hole in the center pillar...
14. ...and the lower seat belt mounting bracket.
15. Remove the upper part of the B-pillar trim.
16. Pry up the edges of the upper rear pillar trim...
17. ...and remove the lining, overcoming the resistance of its holders.
Note: Inspect the trim mounting brackets. Replace any damaged brackets.
18. To remove the lower trim of the rear pillar, fold forward the part of the rear seat back on the corresponding side
19. Remove the retainer and take out the piston securing the lower trim of the rear pillar.
20. Remove the trim, overcoming the resistance of its holders.
21. To remove the rear shelf trim, fold forward the left and right parts of the rear seat back as described in the removal section
22. Remove the retainers of the three rear shelf trim sprinkling pins, remove the pins and remove the trim,
23. Install the interior trims in the reverse order of removal.