The work is shown on the driver's door.
The trim of the right front door is removed in the same way.
Remove the trim of the outside rearview mirror (see Removal the outside rearview mirror).
Putting a rag under the screwdriver, we pry up the decorative frame of the inner door handle and, overcoming the resistance of the clamps..
…we take it off.
In the armrest niche, use a Phillips screwdriver to unscrew the screw that secures the switch block.
We move the switch block back and remove it from the hole in the armrest.
By pressing the lock, we disconnect the wiring harness block from the switch block.
Using a Phillips screwdriver, unscrew the three screws that secure the lower door trim.
Pulling on the edge of the niche for small things..
…we separate the door trim from the inner panel, overcoming the resistance of five pins.
We replace damaged pistons with new ones.
We install the front door trim in the reverse order.
[The material was created based on information from the website: «CHEVYMAN.RU»]