Exterior elements of the car body Chevrolet Aveo 1.5 (T250)

Front mudguard
1. Remove the front wheel. 2. Unscrew the screws and nuts. 3. Remove the fender liner. 4. Installation is carried out in reverse order.

Front bumper
1. Remove the front wheels. 2. Remove the front fender liners. 3. Remove the headlights, turn signals, turn signal repeaters and fog lights. 4. Unscrew the...

Radiator grille
1. Remove the front bumper. 2. Unscrew the screws (1) and the radiator grille (2). 3. Installation is carried out in reverse order.

Hood — removal and installation
1. Open and support the hood. 2. Disconnect the windshield washer hose. 3. Mark the relative positions of the hood and hinges. 4. Unscrew the screws securing...

Front wing
1. Remove the front wheel from the appropriate side. 2. Remove the fender liner. 3. Remove the front bumper. 4. Unscrew the screws (1) covered by the bumper....

Front door — removal and installation
1. Disconnect the negative battery cable. 2. Disconnect the door travel limiter (1) from the door or body. 3. Remove the protective rubber "sleeve" (1) from...

Adjusting the position of the front door
To move the door inward/outward and up/down, loosen the screws (2) securing the lock retainer (1) and move it in the appropriate direction. To move the door...

Front door trim panel
1. Lower the front door window. 2. Remove the cover (1) of the inner door handle. 3. Unscrew the screws (2). Remove the inner handle (3). 4. Pry up and remove...

Front door outer lock handle
1. Remove the front door trim panel. 2. Disconnect the outer door handle rod. 3. Unscrew the screws (1) securing the outer door handle. 4. Remove the outside...

Front door interior lock handle
1. Remove the door trim panel. 2. Unscrew the screw (1) securing the inner handle of the lock. 3. Disconnect the lock rod. Remove the handle (2) and the lock...

Front door lock
1. Disconnect the negative battery cable. 2. Remove the door trim panel. 3. Disconnect the inner door lock handle rod. 4. Disconnect the rod and remove the...

Rear door — removal and installation
1. Disconnect the negative battery cable. 2. Remove the door travel limiter. 3. Unscrew the screws securing the hinges to the door. Remove the door. When...

Rear door lock
1. Disconnect the negative battery cable. 2. Remove the door trim panel. 3. Disconnect the inner door handle rod and the door lock button rod. 4. Disconnect...

Fuel tank filler flap
Unscrew the screws (1) securing the fuel tank flap (2) and remove it.

Trunk lid — removal and installation
1. Disconnect the negative battery cable. 2. Disconnect the electrical wiring from the trunk lid. 3. Unscrew the screws (1) securing the luggage compartment...

Luggage compartment lock
1. Disconnect the negative battery cable. 2. Disconnect the electrical connector. 3. Unscrew the screws (1) and remove the lock (2) of the luggage compartment...

Rear bumper — removal and installation
1. Remove the rear wheels. 2. Unscrew the screws and remove the rear fenders and mudguards 3. Remove the screws behind the rear bumper. 4. Unscrew the bumper...

Gaps between body elements
Door gaps Gaps between elements of the front part of the car Gaps between elements of the rear of the car

Control measurements of the body
The lower part of the car body Front frame Rear frame Front panel Engine bay Back panel Doorways Distances between the edges of the joints of the right and...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: