Car suspension repair Chevrolet Aveo 1.5 (T250)

Front suspension device
1. Stabilizer torsion bar 2. Stabilizer bar nut 50 Nm 3. Stabilizer bar 4. Crossbar 5. Cross member nut (forward direction) 6. Lever connecting bolt 110 Nm 7....

General description of the front suspension
The front suspension of this vehicle is a MacPherson type suspension, which includes the following elements: Stretcher Stretcher (front axle beam) with...

Removal and installation the stabilizer bar assembly with the steering knuckle
1. Disconnect the upper hinge of the stabilizer bar from the shock absorber strut (see figure T250 5.002). 2. Raise and secure the vehicle so that the body...

Removal and installation the steering knuckle
1. Remove the front wheels. 2. Remove the shaft mounting nut in the hub. When installing, tighten the nut to a torque of 300 Nm. Secure the nut by pressing the...

Removal and installation the front suspension arm
Removal 1. Place the vehicle on stands so that the wheels are raised off the floor. 2. Remove the wheel. 3. Disconnect the ball joint from the steering knuckle...

Removal and installation the front subframe
Removal 1. Raise the vehicle and remove the front wheels. 2. Disconnect the ball joint from the lever. 3. Remove the lower stabilizer bar mounting nut. 4....

Disassembling and assembling the front wheel hub
Disassembly 1. Disconnect the drive shaft from the front wheel hub. 2. Remove the inner snap ring. 3. Remove the wheel hub. 4. Remove the outer snap ring. 5....

Removal and installation the front suspension spring
Disassembly 1. Remove the shock absorber struts. 2. Compress the front spring using the front spring compressor. 3. Unscrew the nut securing the upper spring...

The structure and description of the rear suspension
1. Rear suspension beam 2. Upper spring insulator 3. Coil spring 4. Lower spring insulator 5. Shock absorber 6. Upper shock absorber mounting bolt 50 Nm 7....

Removal and installation the shock absorber
Caution: When replacing both shock absorbers, remove and install only one shock absorber at a time. Sagging of the rear axle along its entire length can cause...

Removal and installation rear suspension springs
Removal 1. Raise and support the vehicle properly. If possible, use a contact lift and support the rear control arms with jack stands. 2. Remove the wheel. 3....

Removal and installation the rear suspension assembly
Removal 1. Raise the vehicle. 2. Remove the rear wheels. 3. Disconnect the handbrake. 4. Disconnect the rear wheel speed sensor connectors. 5. Disconnect the...

Removal and installation the rear hub with bearing
Removal 1. Raise and secure the vehicle well 2. Remove the wheel. Note: When removing the brake drum, do not hit the brake drum with a hammer. This may cause...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: