- 1. Rear suspension beam
- 2. Upper spring insulator
- 3. Coil spring
- 4. Lower spring insulator
- 5. Shock absorber
- 6. Upper shock absorber mounting bolt 50 Nm
- 7. Lower shock absorber mounting bolt 70 Nm
- 8. Rear wheel hub bearing journal
- 9. Nut 190 Nm
- 10. Protective cap
- 11. Brake drum
- 12. Shock absorber rod mounting nut 20 Nm
The rear suspension consists of a longitudinal wishbone axle with a curved cross beam, two coil springs, two shock absorbers, two upper spring insulators and two spring compression buffers. The beam support unit is attached to the underbody of the car via a rubber bushing located at the front of each balance arm.
The brackets are one-piece with side cross members on the bottom. Each coil spring is supported by a support on the bottom and a support welded to the top of the rear arm. The lower end of the coil spring is on a compression buffer in a welded bracket on the top of the rear beam. At the same time, a rubber stop is used to isolate the upper end of the coil spring from the support surface on the bottom.