Rear suspension unit of the gearbox with the main gear assembly (Chevrolet Captiva 1)

Necessary equipment

DW 110–060 Engine clamping fixture

Removal procedure

Caution: Raise the engine sufficiently to relieve the load on the rear suspension assembly of the transmission and final drive, otherwise damage to the suspension and failure of the lifting equipment may occur.

1. Support the engine assembly using the DW110-060 engine clamp.



2. Remove the tie bolt securing the gearbox assembly to the rear suspension bracket.

3. Remove the rear gearbox mount bracket retaining bolts from the gearbox.

4. Remove the rear suspension bracket of the gearbox with the final drive assembly.

5. Unscrew the locking bolts of the rear suspension of the gearbox with the main gear assembly from the support.

6. Remove the rear suspension of the gearbox with the final drive assembly.

Installation procedure

1. Install the rear suspension of the gearbox with the final drive assembly on the support.

Tighten

Tighten the transaxle rear mount retaining bolts to 90 N·m (66 lb-ft).

2. Install the gearbox rear suspension bracket with the final drive assembly onto the gearbox.

Tighten

Tighten the transaxle rear mount bracket retaining bolts to 90 N·m (66 lb-ft).

Caution: Before tightening the rear transmission mount clamp bolt, move the engine assembly back and forth or side to side to ensure proper installation.

3. Install the tie bolt securing the rear suspension of the gearbox with the final drive assembly.

Tighten

Tighten the rear transaxle mount to bracket pinch bolt to 90 N·m (66 lb-ft).



(The material was created based on information from the website: CHEVYMAN.RU)