Withdrawal
1. Raise and secure the vehicle well. If possible, use a contact lift and secure the rear arms with stands.
2. Remove the wheel.
3. Remove the lower bolts of the right and left shock absorbers.
4. Lower the rear axle and remove the springs and elastic top spring stop.
Installation
Caution: Before installing the springs, the elastic top spring stops must be attached to the body with duct tape so that they remain in place while the axle assembly and springs are raised.
1. Install the top insulator and fix the bottom buffer.
2. Install the springs and raise the axle.
3. Install shock absorbers.
Attention: the shock absorber mounting bolts are tightened when the car is on the floor and loaded to the extent that it is normally used.
4. Install the wheel.
5. Remove those stands and lower the car.