Removal and installation the rear hub with bearing (Chevrolet Aveo T250)

Removal

1. Raise and secure the vehicle well

2. Remove the wheel.

Note: When removing the brake drum, do not hit the brake drum with a hammer. This may cause damage to the bearing.

3. Remove the brake drum.



4. Loosen the handbrake cable.



5. Disconnect the wheel speed sensor.

6. Remove the wheel hub with the bearing assembly. The bearing unit is fixed in the brake drum and does not move.

Installation

Note: The hub assembly with the bearing is not subject to maintenance. If the unit fails, it must be replaced.

1. Install the hub assembly with the bearing and secure with bolts and nuts. Tighten the nuts to 40 Nm, then tighten them in two steps by 60° and 15°.
2. Connect the wheel speed sensor.

3. Install the brake drum and tighten the screw.

4. Install the rear wheel.

5. Adjust the handbrake.

6. Lower the vehicle.

[The article is reprinted from the website: CHEVYMAN.RU]