Car front suspension Chevrolet Aveo 2 (T300)

Features of the front suspension design
The front suspension is independent, lever-spring type MacPherson, with telescopic shock absorber struts, coil springs, lower wishbones and anti-roll bar. The...

Possible faults of the front suspension, their causes and methods of elimination

Checking the technical condition of the front suspension parts on the car
During each maintenance and repair, it is necessary to check the condition of the protective covers of the suspension ball joints; there should be no...

Removal and installation the front suspension shock absorber
You will need: keys "9", "15", "21" (two), "24", TORX T50, a key for wheel nuts. 1. Brake the vehicle with the parking brake and install the anti-rollback...

Repair of the front suspension shock absorber
You will need: 24 mm keys, TORX T50, spring compressor. NOTE: If strut springs need replacing, replace them in pairs only (right and left at the same time). 1....

Replacing the upper support of the front suspension shock absorber strut
To replace the upper shock absorber strut support, you must remove the strut from the vehicle (see " Removal and installation the front suspension shock...

Replacing the front suspension ball joint
You will need: 17 mm wrenches (two), 19 mm wrenches, a lug wrench, a mounting blade, a drill, and a 10 mm metal drill bit. 1. Raise and support the front of...

Replacing the front suspension arm
You will need: keys "15", "18", "21". 1. Brake the car with the parking brake and install the anti-rollback stops ("shoes") under the rear wheels. Loosen the...

Replacement of anti-roll bar components
For replacement stabilizer struts to ensure lateral stability, perform the following work. You will need: 18 mm wrenches, TORX T40, jack, wheel nut wrench. 1....

Removal and installation the front suspension steering knuckle
You will need: keys "14" (two), "17" (two), "19", Allen key "5", socket head "32", screwdriver with a Phillips blade, hammer, punch, ball joint puller. 1....

Replacing the front hub bearing
You will need: a press or bearing puller, a snap ring puller, a punch, and a hammer. USEFUL TIP: To replace the bearing, it is convenient to use a hub bearing...

Removal and installation the front suspension crossmember
You will need: keys (or socket heads) "on 10", "on 11", "on 11", "on 13", "on 21", "on 13", "on 21" TORX E10, flat-blade screwdriver, container for collecting...

Checking and adjusting wheel alignment angles
Checking and adjusting the wheel alignment angles is necessary to ensure good stability and control of the vehicle, as well as uniform wear of the tires during...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: