2. Remove the shaft mounting nut in the hub. When installing, tighten the nut to a torque of 300 Nm. Secure the nut by pressing the edge of the nut into the groove (every time after unscrewing a nut, it is necessary to replace it with a new one).
3. Disconnect the tie rod end from the steering knuckle.
4. Disconnect the ball joint from the steering knuckle (see figure T250 5.004).
5. Remove the front wheel brake caliper.
6. Remove the brake disc.
7. Remove the wheel speed sensor.
8. Remove the brake disc shield. When installing, tighten the mounting screws to 4 Nm.
9. Remove the shock absorber strut mounting bolts from the steering knuckle. When installing, tighten the bolts to 100 Nm.
10. Remove the steering knuckle.
11 Installation is carried out in reverse order.
(The original source of the article is the website: «ChevyMan»)