NOTE: Operation is shown using the front impact sensor as an example. On a vehicle equipped with side airbags, the side impact sensors are mounted at the bottom of the B-pillars under the trim panels.
The front impact sensor is mounted on the upper cross member of the radiator frame on the engine compartment side.
1. Disconnect the wire from the negative terminal of the battery.
2. Slide the lock of the sensor wiring harness connector.
3. Press the lock and disconnect the sender block.
4. Screw in the sensor mounting bolt a few turns...
5. ...and remove the sensor by pushing the head of its mounting bolt through the enlarged part of the hole in the radiator frame.
6. Install the shock sensor in the reverse order of removal.
NOTE: Apply anaerobic thread locker to the sensor mounting bolt threads.