Drive shafts and cardan car Chevrolet Tahoe 2 and 3

Cardan shaft — design description
Front propeller shaft. 1 - universal joint crosspiece, 2 - universal joint tube, 3 - universal joint crosspiece, 4 - sliding fork, 5 - length compensator boot...

Front propeller shaft
Removal 1. Raise the vehicle and place safety posts under the frame. 2. If installed, remove the transfer case guard. 3. If a length compensator boot with a...

Rear propeller shaft
Removal 1. Raise the vehicle and place safety posts under the frame. 2. Apply marks to the relative positions of the propeller shaft (4) and the flange of the...

Cardan joint — disassembly and assembly
Note: The cross bearing retaining ring may be steel (conventional design) and plastic (disposable ring that is cut off during disassembly). The...

Disassembly and assembly of drive shafts
Disassembly and assembly of drive shafts. 1 - inner CV joint housing, 2 - retaining ring, 3 - inner CV joint crosspiece, 4 - stamped ring, 5 - sliding CV joint...

Drive shaft — removal and installation
Removal Caution: Do not move the vehicle with the drive shaft removed, as the wheel may fall off and cause the vehicle to fall. 1. Raise the vehicle. 2. Remove...

Cover and inner CV joint
Removal 1. Remove the drive shaft. 2. Cut off the stamped ring (2) securing the boot to the CV joint housing (1). 3. Remove the CV joint housing from the shaft...

Cover and outer CV joint
Removal 1. Remove the drive shaft. 2. Cut off the stamped ring (2). Do not damage the surface of the CV joint housing (1). 3. Cut off the small clamp (4). 4....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)