Electrical equipment of the car engine Chevrolet Tahoe 1

Ignition System — General Information and Precautions
The ignition system consists of an ignition switch, battery, coil, low and high voltage circuits, distributor and spark plugs. On 1987-1995 models, a...

Battery — Removal and Installation
1. Disconnect both cables from the battery. 2. Remove the pressure plate (see photo). 3. Remove the battery. 4. Installation is carried out in reverse order.

Ignition system — check
1. The ignition system is checked when the lamp with the inscription starts to light when the ignition is turned on "Service engine soon". 2. When checking the...

Ignition distributor — removal and installation
1. Disconnect the wire connectors from the ignition distributor. 2. Mark the spark plug wire terminal of cylinder 1 (if there are no terminal numbers on the...

Electronic Ignition Module (Pre-1995 Models) — Replacement
1. Disconnect the battery from ground. Remove the air filter. 2. Remove the distributor cap together with the wires. 3. Remove the runner. 4. Carefully...

Induction ignition sensor (before 1995) — checking and replacement
1. Disconnect the battery from ground. 2. Remove the distributor cap and rotor. 3. Remove the ignition distributor. 4. Disconnect the wire from the ignition...

Ignition Coil — Checking and Replacing
1. Disconnect the battery from ground. 2. Remove the air filter. 3. Disconnect the high-voltage wire and the primary winding wire connector from the coil. 4....

Battery Charging System — General Information
The battery charging system consists of a generator with a built-in voltage regulator, a charge indicator lamp, a battery, a fusible link, and wires. The...

Charging system — check
1. First of all, check the condition of the wires and their connections, the fuse link, the integrity and tension of the drive belt. 2. Check the battery...

Generator — removal and installation
1. Disconnect the battery from ground. 2. Disconnect the wires from the generator. 3. Remove the drive belt. 4. Loosen the mounting bolts and remove the...

Brushes and voltage regulator — replacement (only for SI type generators)
1. Remove the generator. 2. Mark the relative positions of the covers and the generator stator with marks to facilitate assembly (see photo). 3. Disassemble...

Starter Motor — Checking Without Removing from the Vehicle
1. If the starter motor does not turn at all when you turn the key, make sure the automatic transmission lever is in the Park position. On models with a manual...

Starter motor — removal and installation
1. Disconnect the battery from ground. 2. Raise the front of the vehicle. 3. Disconnect the wires from the starter and traction relay (see photo). 14.3....

Traction relay — removal and installation
1. Remove the starter. 2. Disconnect the starter power bus. 3. Loosen the mounting screws and remove the traction relay by turning it as shown in the photo. 5....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)