Traction relay — removal and installation (Chevrolet Tahoe 1)

1. Remove the starter.

2. Disconnect the starter power bus.

3. Loosen the mounting screws and remove the traction relay by turning it as shown in the photo.

3. Loosen the mounting screws and remove the traction relay by turning it as shown in the photo.

5. Installation of the traction relay is performed in the reverse order.

[The original text can be found on the website ChevyMan.ru]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 1: Engine electrics

Starter motor — removal and installation
Starter Motor — Checking Without Removing from the Vehicle
Brushes and voltage regulator — replacement (only for SI type generators)
Generator — removal and installation
Charging system — check

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)