Audio system (until 2007) car Chevrolet Tahoe 2 and 3
Removal and installation of the radio receiver Release models up to 2003 1. Write down the radio unlock code (if the radio lock function is provided). 2. Remove the facet of the instrument cluster. 3. Push...
Removing and installing the CD player Type 1 Attention: before carrying out repair work, turn the ignition switch to the position "OFF" or "LOCK" and turn off all electrical loads, except when...
Removal and installation of the amplifier Tahoe 1. Remove the glove box. 2. Disconnect the connectors. 3. Remove the amplifier. 4. Install in the reverse order of removal. Escalade 1. Remove the facet...
Audio system control panel for rear passengers Release models up to 2003 1. Using a slotted screwdriver, remove the rear passenger audio control panel. 2. Disconnect the connectors from the panel. 3....
Removing and installing the microphone 1. Remove the facet of the center console. 2. Remove the cup holder. 3. Remove the glove box of the console. 4. Remove the rear and front trim of the console....
Removal and installation of the rear speaker 1. Remove the top rear trim. 2. Remove the rear corner trim. 3. Remove the speaker. 4. Disconnect the connector. 5. Install in the reverse order of removal.
Removing and installing the speaker in the console 1. Remove the facet of the center console. 2. Loosen the speaker nuts (1). Tightening torque 1 Nm. 3. Disconnect the connector (2). 4. Remove the speaker. 5....
Removing and installing a tweeter 1. Remove the A-pillar trim (2). 2. Disconnect the connector (3). 3. Remove the speaker (1), by squeezing it out. 4. Install in the reverse order of removal.
Removing and installing bass speaker Release models up to 2003 1. Remove the rear side trim. 2. Turn away bolts. Tightening torque 9 Nm. 3. Remove the subwoofer. 4. Disconnect the connectors. 5....
Removing and installing the antenna 1. Remove the top finishing of the panel of devices. 2. Remove the antenna mast. 3. Remove the ventilation grill. 4. Remove the electric pump of the exhaust...
Removing and installing the antenna cable 1. Remove the top finishing of the panel of devices. 2. Disconnect the antenna cable from the radio. 3. Disconnect the antenna cable clamps from the air duct....